I’ve been tuning my Creality K1 ever since getting it (at a steal of $237.15!) about 3 months ago, and I finally got to a point where I’m getting really good, consistent quality results.

Upgrades include:

Strangely enough, the calibration I did that seemed to make the most difference is the one I kept reading was the least necessary to do. I performed an E-step calibration, and ended up changing the rotation_distance from the default 6.9 to 6.86964. Seems nearly identical, but the next print after making that change was the cleanest I’ve seen yet on my printer.

By the way, the print above was run at 600mm/s, with Overture Turbo PLA!

edit: actually no, volumetric speed limited to 25, so not 600mm/s (still fast though!)

I’m now going through and fine-tuning temp, flow, and pressure advance for each of my filaments, and this is just such a different experience than that of my franken-Ender 3; however, I’m still incredibly grateful for all the knowledge and experience I got from constantly tuning that printer for about 3 years straight.

Perfect first layers, every time

  • spitfire@lemmy.worldEnglish
    2·
    8 days ago

    I have it working with a BTT Microprobe (which is very similar to CR-touch). It does not work with the PRTouch which comes with the printer (and is inferior anyway). Eddy is probably much better than either of those. I have the gantry mode printed and pre-assembled but decided not to go with it. Maybe someday if something breaks and I’ll have to tear printer apart anyway. When you’re saying extruder you mean the hotend?