Whut? Basically every 3D printer does print way above that (300°+X is the industrial norm for more advanced new printers now e.g. Centauri Carbon, Artillery M1 Pro, BL, etc.). 250° is absolutely nothing out of the ordinary these days and can be achieved by basically every 3D printer a major brand brought out in the last two years. Even the A1mini can do so.
Polymaker’s ASA is recommended to be printed at 250° and Formfuturas ASA, BL ABS, Formfutura ABS(reTitan), Fiberology,
For Polymakers ABS the lowest temp recommended starts at 245°C, goes up to 265.
Most Nylons, PCTG start above 250°C as well. And let’s not even start about proper high Temperature materials like PEEK,ULTEM,PEI.
Don’t get me wrong,but maybe your temp sensor is off(not unheard off in Vorons) or your settings are off. I have yet to see someone get ASA printed well with settings well below the recommendations.
Centauri Carbon: Around 300 bucks
Bambu Lab A1 mini: Around 200 bucks
How much more entry level can you get? That’s below most Voron builds, btw.
You came in here with a claim that was simply not valid.
The most likely explanation is that your printer is misconfigured.
But you keep on generalising your subjective experience towards everyone else,even though you have been disproven.
Whut? Basically every 3D printer does print way above that (300°+X is the industrial norm for more advanced new printers now e.g. Centauri Carbon, Artillery M1 Pro, BL, etc.). 250° is absolutely nothing out of the ordinary these days and can be achieved by basically every 3D printer a major brand brought out in the last two years. Even the A1mini can do so.
Polymaker’s ASA is recommended to be printed at 250° and Formfuturas ASA, BL ABS, Formfutura ABS(reTitan), Fiberology, For Polymakers ABS the lowest temp recommended starts at 245°C, goes up to 265.
Most Nylons, PCTG start above 250°C as well. And let’s not even start about proper high Temperature materials like PEEK,ULTEM,PEI.
Don’t get me wrong,but maybe your temp sensor is off(not unheard off in Vorons) or your settings are off. I have yet to see someone get ASA printed well with settings well below the recommendations.
i was talking about hobby and entry level printing. nevermind. you folks are a lot of fun…
Centauri Carbon: Around 300 bucks Bambu Lab A1 mini: Around 200 bucks
How much more entry level can you get? That’s below most Voron builds, btw.
You came in here with a claim that was simply not valid. The most likely explanation is that your printer is misconfigured. But you keep on generalising your subjective experience towards everyone else,even though you have been disproven.