cm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 3 days agoPrintGuard Is a New Open Source 3D Printing Failure Detector That Runs on the Edgewww.hackster.ioexternal-linkmessage-square16fedilinkarrow-up160arrow-down12
arrow-up158arrow-down1external-linkPrintGuard Is a New Open Source 3D Printing Failure Detector That Runs on the Edgewww.hackster.iocm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 3 days agomessage-square16fedilink
minus-squareAppearanceBoring9229@sh.itjust.workslinkfedilinkEnglisharrow-up1·2 days agoDown anyone know of it works with belt printers? I had it, but it kept restarting some prints that were fine and never detected a failure :(
minus-squarenickwitha_k (he/him)@lemmy.sdf.orglinkfedilinkEnglisharrow-up2·1 day agoMy suspicion would be that belt printers were not in the scope when writing it. Probably a good idea to open an issue in GitHub so that they can fix it.
Down anyone know of it works with belt printers? I had it, but it kept restarting some prints that were fine and never detected a failure :(
My suspicion would be that belt printers were not in the scope when writing it. Probably a good idea to open an issue in GitHub so that they can fix it.